P0744 Engine Trouble Code
Meaning of P0744 engine trouble code is : When the check engine light comes P0744 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.
P0744 Possible Solution:
Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.
P0744 Code Meaning :
|OBD-II Diagnostic Powertrain (P) Trouble Code For Engine||Intake Valve Control Solenoid Circuit Low||Fuel Rail Pressure Sensor Circuit Malfunction||Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)||Timing Reference High Resolution Signal A Too Many Pulses|
The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.
P0744 OBD-II Diagnostic Powertrain (P) Trouble Code DescriptionP0744 OBD-II Trouble Code The Torque Converter Clutch (TCC) solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control M P0744 code.
Reason For P0744 CodeThe reason of P0744 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.
P0744 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.